Here you will find files that you can instant download to print and press for your cheer bows.
There are several designs listed and some are JPEG format while others are VECTOR format.
JPEG format are high resolution images that are ready to print and press onto your ribbon/glitter.
VECTOR format come in eps and svg formats so that they are editable where you can change up the colors, size, etc.
You will need a heat press to press the sublimation bow files (that you do not use vinyl for) a household iron will not work as it will not get hot enough to for the sublimation process
INSTRUCTIONS FOR PRINTING-PRESSING THE SUBLIMATION CHEER BOW FILES
Pre-press (kiss press) your glitter htv (heat transfer vinyl) onto your grosgrain ribbon. (You will do half the bow at one time) Example: 28 inch bow you would need (2) 14 inch long pieces of glitter htv.
Print out your sublimation bow strip design.
Apply tape on each end of the sublimation transfer to be pressed and tape face down onto your pressed glitter grosgrain ribbon. (Again you will do half the bow at one time)
Apply protective paper onto the bottom of your press (un-waxed butcher paper or parchment paper works great)
Bring over prepared ribbon with transfer attached to your ribbon and press with ribbon on bottom/sublimation transfer on top.
Apply protective paper onto the top of your ribbon/sublimation transfer.
Press at 400 degrees for 60 seconds.
Don't take any shortcuts or think you are pressing too long. You will want to go the full 60 seconds at 400 degrees so that the gas in the sublimation ink releases onto your glitter/ribbon to produce the best colors.